|
Answer the following questions without referring to the material just presented.
- Starters are made from two building blocks, _____________ and ____________ ___________.
- Reduced voltage starters are used for two main reasons. These are:
To avoid overloading the _______ __________ ________.
To avoid unnecessary wear and tear on equipment by _______ __________ ___________.
- The earliest developed type of reduced voltage starter is the __________ __________ reduced voltage starter.
- Draw lines to match each type of reduced voltage starter to its common application type:
| 1. Solid State | A. Centrifugal compressors and centrifuges |
| 2. Wye Delta | B. Belt and gear drives, conveyors and textile machines |
| 3. Primary Resistor | C. Blowers, compressors and conveyors |
| 4. Part Winding | D. Machine tools, hoists and packaging equipment |
| 5. Autotransformer | E. Reciprocating compressors, pumps and fans |
- To allow smooth operation to continue throughout the start-up process, the ______ __________ type of wye delta starter uses an extra ________ and a set of _________.
- The least expensive of all the reduced voltage starting methods is ______ ________.
- The most important factors in determining the size of the starter the customer requires, are the application’s __________________ and __________________.
- List six of the pieces of application information you will need to obtain from the customer before you can recommend a specific reduced voltage starter.
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
|
